high current dc motor control
The subject: high current and low voltage DC motor control
Writing about the (dc to dc converter 5-12V) ? what is the function for it ? the reason I use it in the circuit?
Calculate all the circuit and do as you can for calculations ?
Writing about diode zener 15V and the function for it ?
Writing about the mosfet (IRFP3206PbF) Vdds 60V, Id= 200A and calculate it with test by multisim if you can ?
Compare between MOSFET and BJT ? and why I use MOSFET better than BJT in this circuit ? I think the answer because the current is too high that is why I use mosfet.
And why I get +36V ? because it’s 24+12=36V.
Calculate the circuit for 555 timer ? and writing about 555 timer ? and I have already done the testing in multlisim and just write about it.
and I would like all the reference from web-side.
I will keep it more easy for the writer:
1- Compare between MOSFET and BJT ? and why I use MOSFET better than BJT in this circuit ? 2 pages
2- write about the MOSFET (IRFP3206PbF), not more than 1 page and this is the link for it http://www.irf.com/product-info/datasheets/data/irfp3206pbf.pdf
3-((write about DC motor; 3 pages
votage for the motor is = 24V dc
ratedspeed = 2750RPM
; with calculation and design the current and the voltage for it and the speed)) and you can look in the circuit that I posted in the file and it is call it “scan1”, just feedback I will connect the motor to H-bridge that is why I will use mosfet(IRFP3206PbF) as switching because the high current.
4- write about the diode zener 15V that I use it in the circuit, what is the function for it. 1 page
5- write about the 555 timer that I tested in multisim and what is the function for it with a calculation . and I will connect the 555 timer to the chip ISL83202 AND TO THE PIN 4(ALI) LOOK TO THIS LINK http://www.icbase.com/File/PDF/INT/INT09201401.pdf . 4 pages
6- write about the component (NMG0512SC) AND SEE THE DATASHEET) (dc to dc converter BOSSTING 5-12V ) ? what is the function for it ? the reason I use it in the circuit? 2 pages
7- make content without conclusion, introduction and abstract.
8-referencing must be excellent and all the referance i want it by web-side and use formal,’technical report’style. add please make sure the plagiarism less then 10% turninit.